Showing posts with label Health. Show all posts
Showing posts with label Health. Show all posts

Shave the mustache with a razor

Shave the mustache with a razor

Shave the mustache with a razor

Instructions

1

Decide what type of moustache style that you want. According to men's health, your mustache should not be wider than the corners of your mouth. If your lip is thin, keep your full mustache to give the illusion of fuller lips, but if you lips are full, go to room for a small mustache.

2

Paint the mustache down with a comb. Cut off excess and unruly hair with scissors and hair that falls below the threshold of the lip.

3
Take a hot shower or bath before shaving. The steam from the water softens the facial hair, which gives you a smoother, closer shave.

4

Massage the area of the mustache with your fingers for about two minutes. Put a quantity of size quarter shaving cream or gel between your hands.

5

Pour the cream to shave your hand with a Badger. Spread the cream or gel on your moustache area, so it is completely covered. Using a shaving brush to apply shaving cream is better using your fingers. Note "GQ Magazine" shaving brush to apply the cream evenly and exfoliates the skin to lift the hair.

6

Massage the area of the mustache again for a minute with your fingers. Wet your Shaver in water and shave the moustache in the style you have chosen. Hover over the Shaver gently your mustache in the direction of the hair growth. Rinse the Shaver after each pass to remove the excess cream shaving and hair.

7

Rinse the area of the mustache with cold water once that you shaved it to your liking. You are looking for a missed points. If you find, put a small amount of cream shaving on the area and shave unwanted hair.

8

Apply after shaving on the area to close up your pores and soothe the skin. Rub the shaving balm on the area of the moustache to add moisture.
Shave,the,mustache,with,a,razor

Enhanced by Zemanta

Dry the face for men shaving

Dry the face for men shaving

Dry the face for men shaving

Instructions

1

Recharge the Shaver completely before. Depending on your model Shaver, loading can take up to eight hours or more.

2

Apply a small amount of lotion containing alcohol for the pre-shave to your face. Rub the lotion on your cheeks, Chin, upper lip, and anywhere else that you want to shave. Alcohol stiff facial hair is easier to remove with shave dry. Do not wash your face or moisten with water.

3
Use one hand to stretch the skin you want to shave. Stretching of the skin allows the Shaver to glide on easily, so you'll get a closer shave.

4

Turn on the electric shaver. Gently press the Shaver to your skin. You do not need to press hard; light skin contact is sufficient.

5

Pull the Shaver upwards or downwards against the face to remove hair. With an electric razor, you can shave with or against the grain of your hair growth. If you have a rotary Shaver, press the blades very gently on your face and move the Shaver using small circular movements. This continues until you have removed all the desired facial hair.

6

Rinse your face with warm water to wash the remnants of lotion and loose hair.

7

Pat your face dry with a clean towel. Do not rub your face; This may cause irritation.

8

Apply a balm after shave without alcohol on your face to moisturize the skin.
Dry,the,face,for,men,shaving

Enhanced by Zemanta

Applique Satin strands of human hair


Applique Satin strands of human hair

Applique Satin strands of human hair

Instructions

Clip-in hair Extensions
1

Brush all the tangles from your hair.

2

Separate your hair, using a rat tail comb, where you want to place the satin clip-in strands. Clip-in extensions should start from the bottom of your head, moving upwards.

3
Raise all the hair over the part and clip, with a clip of duck.

4

Snap open all the clips on the weft of the strands of satin. Place the frame on your own hair, the top of the frame is even the part in your hair. Continue this process until all the clips in the frame are attached to your hair.

5

Remove the duck clip that keeps your hair from the road.

6

Make a new part in your hair where you want the additional satin strands in place. Repeat steps 2 through 5 until the desired look is achieved.

Gluing hair extensions

7

Brush all the tangles from your hair.

8

Separate your hair, using a rat tail comb, where you want to place the weft thread satin. The placement of the frame should start from the bottom of your head, moving upwards.

9

Raise all the hair over the part and clip, with a clip of duck.

10

Apply adhesive that sticks to the frame of the satin strand. Carefully place the frame to the top of the part in your hair. Once the glue is dry, continue to add the strands of satin, until the desired look is achieved.
Applique,Satin,strands,of,human,hair

Enhanced by Zemanta

Make an Italian weaving

Make an Italian weaving

Make an Italian weaving

Instructions

Customize your armor
1

Determine the best armor in length for your lifestyle. Italian woven come in 12, 14, 16 and 20 inches in length, and you can prune before or after they are committed. If you have an active lifestyle and a longer duration, consider wearing your hair upwards and covering it while you sleep. You can always wear it down on special occasions.

2

Use a hair clip to keep the hair on the top of your head upward and out of the way. From the temple, part evenly on each side of your hair, move the comb from the front to the back, ending by the centre. Gently twist the hair and use the claw of the secure above your head.

3
Downstairs, leaving a small band of your own hair, part your hair in the back up to your ears. Use the hair clips to keep the your hair out of the way so you can measure your neck through.

4

Use a piece of string to measure the distance between your ears on the back. Grasp the end and hold it to the ear and stretch the chain through the distance and the other ear. Cut the string is equal to the distance.

5

Remove the clips and continue the process of cutting and measuring chain. For each line, move an inch upward on the back of your head. As you measure for each line, tape the strings to a piece of paper and label each of them.

6

Layout the armor on a large flat surface. Using measured chains estimate, pretty layout sections of frame for each row that you want to fill. Don't forget that you will work the neck upward, both layout sections of weaving in the same order.

7

Begin the process of collage frame from your scalp to the nape of the neck. Yet once, part your hair in the back of one ear to the other and cut your hair, leaving a small band of your own hair down.

8

Apply a thin layer of glue of hair on each section of frame extension and a thin layer along the part. Allow glue to dry slightly, until it feels tacky. This technique will allow the frame to stick securely to your scalp.

9

Working from the Center, press each section tightly against the scalp. The glue will dry quickly, so place each section carefully. For a natural look, leave about a 1/4 inch of space for your own hair to each end of the part. Repeat this process until the desired number of lines is glued in place.
Make,an,Italian,weaving

Enhanced by Zemanta

Keep a wavy weave from drying out

Keep a wavy weave from drying out

Keep a wavy weave from drying out

Wash
Wash your hair with a mild, moisturizing shampoo once every 7-14 days. Wash loose the armor and can dry out the extensions, natural oils that is missing, so avoid washing your hair more frequently than once a week. Concentrate the shampoo on your scalp, smoothing gently on the hair weaving without rubbing or scrubbing. Avoid messing your head while shampoo or conditioning, which could make the armor permanently tangle. Rinse and blot with a towel.

Air conditioning
Moisturize your natural hair and your armor with a leave in conditioner after the shampoo. Avoid shampoos and conditioners with silicone, which can cause extensions slide. Massage the product with your fingers, gently coating strands and to avoid the area where the extensions are glued to your natural hair. Avoid oils which may cause dull extensions or tangling. Detangle with a wide toothed comb if you have waves more cowardly, or use your fingers to comb the waves more tight to keep them intact.

Drying
To allow the armor to air dry. Heat can cause the armor to dry and to loosen the links, so it is better to avoid using a dryer, when possible. If you have dry, use the lowest heat and speed setting. When the shampoo during the night, ensure that your hair is completely dry before going to bed to avoid tangling, matting or a musty smell.

Styling
Extensions wavy style between shampoos wetting their daily lives and sprinkled with leave-in conditioner to keep them looking shiny and glossy. Avoid using styling products that contain alcohol, which can damage your armor. Brush extensions at least twice a day to help keep your tangle-free hair. Use a boar paddle brush or a Tong that features special brush loop specially designed to gently hair extensions and style wigs without snagging or catching the bristles. Comb or brush movement downwards starting from the ends and gently work your way upward. Normally, the stylers heated must serve on extensions human hair 100%, preferably with Ionic devices, ceramic. Avoid using stylers heated on synthetic hair. Test a small bit before styling with a curling iron or flat iron and use the lowest possible temperature. Consider using a daily build jet, designed to condition and detangle synthetic and human hair while maintaining the link. Just a spritz or two will keep your hair soft, shiny and manageable.
Keep,a,wavy,weave,from,drying,out

Enhanced by Zemanta

Comb the curls in weaves

Comb the curls in weaves

Comb the curls in weaves

Instructions

1

Place your hand at the level of the joint. This is where the weave hair responds to your natural hair. Place a wide-tooth comb in your other hand.

2

Comb the hair with one hand, starting from the ends. While you paint, lift the hinge slightly to alleviate pulling and pulling. Too big combing can damage your natural hair. Once the ends of the hair are untangled, combing the hair to the top just below the joint. Do not drag or pull the gasket. You can loosen your armor. You must comb the armor in the morning to refresh your curly look.

3

Squirt a leave in conditioner in the Palm of your hand. Scrunch the conditioner on the ends of your natural hair weaving. If you wear a synthetic weave, use moisturizing products, suggested by the manufacturer. The produced work in the hair, but do not apply the moisturizer to the joint. This could loosen the armor and slide it towards the bottom of the hair.
Comb,the,curls,in,weaves

Enhanced by Zemanta