Dye your armor boards

Dye your armor boards

Instructions

1
Working a comb with wide teeth through your armor to remove all knots or snarls. Lightly flour the difficult snarls with a leave-in conditioner to avoid damaging your armor. If you do use a leave-in conditioner, make sure to wash and dry hair thoroughly before dyeing.

2
Drag onto an old shirt or hang a towel over your shoulders to prevent the spread of the dye to your skin.

3
Divide your hair into sections of 1 to 2 inches approximately 1-2 inches deep. Tie or clip about 1 to 2 inches from the end of each section.

4
Slip on the gloves provided in the hair dyeing kit and mix developer and hair color according to the instructions.

5
Moisten a small brush with the mixture and apply it on the sections below the clip in plastic or ponytail. Visibility, start either the left or right of your head. If your hair is long, ask a friend for assistance.

6
Allow the dye for the hair to be treated according to the directions on the packaging. Remove the clips or rubber bands and rinse your hair under a water faucet warm up until the water is clear.

7
Apply the conditioner provided in your hair color Kit to your dyed tips and allow him to go for two or three minutes.

8
Rinse the conditioner from your advice and comb the hair to a uniform distribution. Dry hair and style as usual.

9
Throw the plastic bowl used to mix the color of hair.
Dye,your,armor,boards

Categories: Hair Care